?
温州大学GDS真三轴TTA系统使用案例
发布时间:2018-12-28
THE VEHICLE LOADING SIMULATED BY GDS TESTING APPARATUS


USERS: MR WANG, GEOTECHNICAL ENGINEERING RESEARCH GROUP, CIVIL ENGINEERING, WENZHOU UNIVERSITY; KEY LABORATORY OF ENGINEERING AND TECHNOLOGY FOR SOFT SOIL FOUNDATION AND TIDELAND RECLAMATION OF ZHEJIANG PROVINCE.





THE PROBLEM

 
Soft clay is widely distributed in southeast coastal cities of China, such as Shanghai, Hangzhou and Wenzhou. It has been recognized as one of the most problematic soils in China because of its high water content, high compressibility, low permeability and low bearing capacity. In the past decades, a large number of infrastructure projects have been constructed on this kind of soil. After years of operation, large settlements of the subgrade have been observed. Therefore, it is essential to study the deformation behaviour of soft clay under traffic loading to prevent this. As the subgrade soils are subjected to large numbers of load applications (105 – 106 cycles) at a stress level below their shear strength, the deformation behaviour of soft clay under a large number of load cycles (i.e., long-term cyclic loading) is of particular importance.
According to figure 1, the dynamic stress field induced by moving loads is three-dimensional, involving the cyclic variation of major, intermediate and minor principal stresses (σ11, σ12, σ22) however, limited laboratory studies have actually been undertaken on the one-way deformation behaviour of saturated clays in three-dimensional stress state.

Fig.1. Stress components of the soil element in soft subsoil induced by vehicle loading


GDS Instruments Advanced True Triaxial device was chosen to carry out the research. It applies the confining pressure by water pressure, which is further provided by the compressed air. The cyclic vertical stress (Δσ1) and horizontal stress (Δσ2) in the direction of σ2 are provided by two horizontal metal plates with length=75mm and width=75mm and two vertical metal plates with width=75mm and height=140mm, respectively. Every metal plate is driven by a high-precision servo motor.

Fig.2. (a) The overall schematic, (b) the detailed schematic, (c) photo of the true triaxial apparatus and (d) photo of the pressure chamber.



Fig. 3. Time-history curves of major principal strain



In the Advanced True Triaxial tests, different combinations of cyclic major and intermediate principal stresses were applied. The typical time-history curves of major principal strain, ε1, are given in Fig. 3. When CSR is relatively low, although the development of strain is rapid at the beginning of the tests, after certain cycle numbers, the development slows down quickly and tend to be slight or even zero. When CSR becomes larger than a certain value, the strains develop rapidly and failure can occur within a specified cycle number.



CONCLUSION & TESTIMONIAL


The Advanced True Triaxial apparatus, which can apply cyclic major and intermediate principal stresses simultaneously, was employed to carry out a series of one-way cyclic tests on both normally and over-consolidated clays. Over-consolidation ratio, cyclic intermediate principal stress (bcyc), and cyclic shear stress ratio were considered, allowing the one-way cyclic behaviour in 3D stress state to be investigated.
 
Test results show that the increase of bcyc greatly reduces the development of major principal strain, and changes the direction of intermediate principal strain from tension to compression. This implies that OCR is a minor factor in the effects of cyclic intermediate principal stress on the deformation characteristics of saturated clay. Furthermore, based on the results, an empirical model is proposed, allowing the long-term deformation of saturated clays to be predicted in three-dimensional cyclic stress state.
 
During the testing process, experts from GDS were on hand to answer any queries. We will continue to cooperate with GDS and look forward to working with them again in the future.



REFERENCES


Gu, C. Gu, Z. Q., Cai, Y.Q., Wang J., and Dong Q. Y. 2018. Effects of cyclic intermediate principal stress on the deformation of saturated clay. Journal of Geotechnical and Geoenvironmental Engineering, 144(8): 04018052.
Brown SF. Soil mechanics in pavement engineering. Geotechnique 1996;46(3):383–426.
 
Chazallon C, Hornych P, Mouhoubi S. Elastoplastic model for the long-term behavior modeling of unbound granular materials in flexible pavements. International Journal of Geomechanics, ASCE 2006;6(4):279–89.




后记:

作者工作单位介绍

Key laboratory of engineering and technology for soft soil foundation and tideland reclamation of Zhejiang province, was founded in 2006. Now the laboratory mainly focus on four key techniques: high-speed traffic engineering construction on thick soft ground, levees construction on thick soft ground, underground engineering construction on thick soft ground and land reclamation development and construction along the coastal industrial belt. The laboratory has an area of more than 2,000 square meters for research and has research instruments worth more than 30 million yuan. The research results had been applied to the construction of Wenzhou Yiongqiang airfield runways, Wenzhou City Highway and projects on the development of underground space in coastal industrial belt of Wenzhou and so forth.




GDS案例



推荐方案
返回
官方公众号
官方微博
电阻应变片,地震仪,测斜仪,测井仪 高科技测试仪器全面解决方案提供者
  • 400-700-9998
  • 服务时间 : 周一至周日9:00-18:00
  • E-MAIL : marketing@epc.com.hk
版权所有 糖果派对送50,糖果派对官网,糖果派对官网下载 Copyright ? 2008~2021 Earth Products China Ltd. all rights reserved. 粤ICP备12064742号 大陆总部地址:广州市天河区体育东路116号财富广场西塔2301 香港公司地址:香港葵涌梨木道79号亚洲贸易中心12楼 热搜关键词:静态应变仪_位移传感器_木材检测仪_三维探地雷达_路面病害检测_超声波检测_燃烧性能测试_路面材料试验机_动态数据采集仪 超声波检测,地震振动台_标线逆反射_自钻式旁压仪_岩体三维成像_无线数据采集仪_螺栓应力测试_逆反射检测仪_光纤光栅传感器_高层建筑健康监测
首页
糖果派对官网
解决方案
糖果派对送50
友情链接:uedbet-uedbet赫塔菲官网  手机下注APP-官网首页  og真人注册-og真人注册网站  秒速快三计划-官方官网-秒速快三计划  秒速飞艇-秒速飞艇官网  188电竞-188电竞平台-188电竞官网  电竞竞猜app-电竞竞猜app官网-电竞竞猜app平台  沙巴官网-沙巴官网APP  现金真人网站-现金真人网站-真人APP网站  18体育_18体育平台